Web Instruction Manual
Wireless display (trial version)

Wireless display (trial version)

You can display the screen of a Windows computer on this product (mirroring and an extended display).

To use this feature, update the glasses software.

Note

  1. These operations cannot be performed while you are using the linkage feature of your smartphone. Exit the linkage feature of your smartphone beforehand.

  1. The connection may not be established depending on the Windows computer model or system settings.

  1. The display may be disturbed or video/audio may freeze due to external factors such as the wireless environment. If the video/audio freezes, disconnect and reconnect it on the connected computer.

  1. Residual images may remain on the display of this product (the glasses) after disconnecting from Wireless display. To resolve this, try reconnecting and disconnecting from the source device, or restarting this product.

  1. If you see a message stating that a connection cannot be established with the source device when you try to connect, try reconnecting from the source device.

  1. When the glasses information is registered on the source device, delete that information. If the connection failure persists, restart this product.

  1. If Wireless display does not start after tapping the touch sensor on the confirmation dialog of this product, try reconnecting from the source device.

  1. 1920×1080 is recommended for display resolution on the computer. Content may not be displayed on this product properly depending on the display resolution.

  1. Some items in the display settings on the computer are not reflected in Wireless display.

  1. The battery level is not displayed while using Wireless display. Use this product while charging for extended use.

  1. Start Wireless display on the computer.

    1. Ensure that Wi-Fi® is enabled on the source device beforehand.

    1. Pressing the Windows key and K key simultaneously will open the connection destination selection screen.

    1. Select “MiRZA_xxxx” (this product) on the dialog for selecting a connection destination.

    1. The confirmation dialog for starting Wireless display appears on this product.

    Tip

    1. When connecting to a computer that was previously connected via Wireless display,  the confirmation dialog will not appear, and Wireless display will start.

    1. You can select a display mode from the connected computer, such as Duplicate, Extend, or Second screen.

  2. Tap the touch sensor.

    Wireless display starts.

    Tip

    1. To cancel Wireless display, long-tap the touch sensor.

    1. While using Wireless display, you can adjust the speaker volume by pressing the ＋/－ button of this product (but, the volume/brightness adjustment bar does not appear).

    1. If you do not hear any sound from this product or the volume is too low, check the volume setting of the connected device. The volume settings of this product and the connected device are controlled independently.

  3. Disconnect from the connected computer to end Wireless display.

    For detailed operations, refer to the manual of your smartphone or computer.

Related Topic

Copyright  NTT QONOQ Devices, Inc.